SKY87000-13-001

Step-Down Regulator with Auto-Bypass LDO for Multi-Band/Mode RF Power Amplifiers


Please note: SKY87000-13-001 is being discontinued and is not recommended for new designs.

The SKY87000-13 dynamically controls the operating voltage of a multi-mode WCDMA or GSM/EDGE Power Amplifier (PA) solution. The SKY87000-13 outputs a voltage between 0.40 V and 4.25 V, giving optimum efficiency for all operating states.

The output voltage of the device is controlled by an analog signal from the baseband processor. The SKY87000-13 can support up to 2 A of total load current with step-down and bypass regulators. The 2 MHz switching frequency is optimized for a typical 2.2 μH inductor and reduced output capacitance.

To further improve system performance, an 85 mΩ bypass linear regulator is included that allows the PA to be powered directly from the battery. The bypass regulator output voltage is offset from the step-down regulator, which improves extreme load transient and dynamic output transition performance.

The SKY87000-13 is available in a 9-bump Wafer Level Chip Scale Package (WLCSP) with 0.5 mm pin pitch.

Specifications

Product LifecycleLast Time Buy
Min. VIN (V)2.7
Max. VIN (V)5.5
Min. VOUT (V)0.4
Max. VOUT (V)4.25
IOUT (mA)2000
fOSC (kHz)2000
Typ. IQ (μA)135
PackageWLCSP, 9-bump
Package (mm)1.420 x 1.490 x 0.650

Features

  • Input voltage range: 2.7 to 5.5 V
  • Dynamic output voltage: 0.4 V to 4.25 V
    • 0.16 V to 1.7 V reference input range
    • 2.5 times the reference input voltage to regulator output gain
  • Internally compensated current/mode architecture:
    • 2 MHz switching frequency
    • 2.2 μH chip inductor
    • Two 4.7 μF output capacitors
    • Wide duty cycle range (100% duty cycle operation)
  • Integrated 85 mΩ (typical) bypass regulator
  • Less than 10 μs response for 1 V output step
  • Up to 2 A typical output current
  • Small 9-bump WLCSP package (MSL1, 260 °C per JEDEC J-STD-020) package

Product Documents